1
Zero Motorcycles Forum | 2012 and older / 2010 Zero S Not charging
« on: May 10, 2023, 02:37:05 PM »
Just fitted a new battery pack ( after Nissan leaf packs blowing up and failing, not sure why) and now the DeltaQ charger won’t charge the bike ( tried 2 and both the same, straight to red light not even going up the 4 bar scale or to the 80% mark )
Voltage good at 52v so not under or over voltage, BMS does a single check beep self diagnosis when connected.
Stand switch is disabled
The bike powers on and actually moves but has the small red “warning LED” on permanent red 🤔
Want to know how to check the interlock function and try fooling the system. Is it a 5V negative feed to the interlock wire ?
What happens then? Does that make the BMS or MBB send a signal back to the charger to initiate charging ?
Any help or ideas appreciated
Voltage good at 52v so not under or over voltage, BMS does a single check beep self diagnosis when connected.
Stand switch is disabled
The bike powers on and actually moves but has the small red “warning LED” on permanent red 🤔
Want to know how to check the interlock function and try fooling the system. Is it a 5V negative feed to the interlock wire ?
What happens then? Does that make the BMS or MBB send a signal back to the charger to initiate charging ?
Any help or ideas appreciated