ElectricMotorcycleForum.com
Makes And Models => Zero Motorcycles Forum | 2012 and older => Topic started by: pluto on April 18, 2014, 01:16:35 AM
-
Wondering if anyone has installed these on a 2012 (XU)?
http://www.lights.skenedesign.com/P3_Features.shtml (http://www.lights.skenedesign.com/P3_Features.shtml)
-
I have the IQ160TS on my ninja 250 and love it.
However I didn't buy the P3 modules instead I bought a lot of IP67 'tape led' and modified one of my givi cases so I have about 60+ leds as my rear "get the F off my ass" brake lights. Oh and they work wonders btw.
I use the 4 quick 4 slow solid brake light setting.
https://www.youtube.com/watch?v=ffz8aEnKSdM (https://www.youtube.com/watch?v=ffz8aEnKSdM)
-
Thanks. I don't have a top case on my XU (haven't figured out how to attach a mounting bracket...) so I think the license plate mount option would work better. Just wondering if there is anything special about the Zero that would complicate the install though.
-
I can't think of anything that would make it difficult. Are you doing the TS model or the normal one? I believe they send you some positaps so you don't have to solder anything. I liked the positaps so much I ordered a bunch of them to use on my ninja.
-
I'm thinking to get the TS model
-
Just wanted to post that I've installed the Skene P3+TS on my 2012 XU successfully
(http://i.imgur.com/TrkXjMvl.jpg)
I tapped into the tail light / brake light and signal light wires under the seat, and mounted the controller box there too.