ElectricMotorcycleForum.com

Tech => Tech Help => Topic started by: Camresearch on August 27, 2015, 11:46:34 AM

Title: Dimensions of brushes
Post by: Camresearch on August 27, 2015, 11:46:34 AM

Hi Guys,

I was after the exact dimensions of new brushes on an Agni 95r motor in a DS 2010 zero, I was wondering if anybody knew or could measure them for me.  Length of pig tail, width, length and thickness please.  I am in Australia and I can get brushes made but I don't have the proper dimensions.

Cheers, Cam  8)

Title: Re: Dimensions of brushes
Post by: firepower on August 28, 2015, 01:44:25 PM

you can measure the width and height from your existing brushes, and using photos from link can get approx length of brush and pigtail.

(http://www.jozztek.com/shop/14-53-large/set-of-8-matching-agni-brushes.jpg)

http://www.jozztek.com/shop/agni-motors/14-set-of-8-matching-agni-brushes.html (http://www.jozztek.com/shop/agni-motors/14-set-of-8-matching-agni-brushes.html)

Title: Re: Dimensions of brushes
Post by: Camresearch on August 28, 2015, 03:06:22 PM

I don't really want to take the motor out again, just to measure them.  Jozztek, won't have them until the end of September and then they would have to come from the UK to Australia.  I can get a guy here to make them cheaper but I didn't measure them when I had them out.  I should have in hindsight. 

Cheers,
Cam

Title: Re: Dimensions of brushes
Post by: Camresearch on September 02, 2015, 03:20:36 PM

Since my motor burned up again, I have taken it apart.  Just for future reference.  The brushes are 2 mm thick and 19 mm wide.  Length I am uncertain as there isn't much left.  Pigtails are 75 mm measured from the end of the connector to the base of the brush. I would estimate the original length to have been approx 25 to perhaps 30 mm... As I said, not sure on that one.

Cam  8)