3
« on: March 20, 2018, 07:40:21 AM »
Igorbaldo,
That is great, thank you for doing that wiring diagram. I have a question for you.
So I just got my 2011 Zero XU and I got it with a dead battery. So I took about 4 days to slowly charge each of the 7 banks (2 of the cells that are stacked in series on top of one another). I charged them at 1 amp with a car/motorcycle charger 6v. Until I got each bank to about 6.5 volts with a total of 45.5 volts. I kept those cells that I got to that voltage, using a computer power supply and a step up. After getting to the 45.5 volts I connected it back to the charger on the bike ant started charging!
So the battery is not in the best shape, with it being that low for well over a year. So with the way the battery is it will cut out around 38mph because it doesn't have enough amps to push out when I need it. (I tested it with another battery I built in parallel and it worked with out cutting out). I was also able to travel about 6 miles and then it would cut out completely with original battery.
So this brings me to the next step in my adventure. I took this pack that I made from 14 3.7v 24ah li-ion cells from a Ford C-Max. ( I did this to make it a faster build.)
So I got everything ready but I very sadly hooked up the BMS in the exact opposite order needed and I fried my BMS.
With that can you, Igorbaldo or anyone else, tell me by chance what the voltage is going from the KSI to the MBB. The Br and B?
Thank you
