1
Zero Motorcycles Forum | 2013+ / Re: C13 Socket replacement
« on: February 07, 2023, 04:24:41 AM »Don’t worry about plugging in the bikes plug 1st as the contractor pull-in is delayed but don’t unplug it first (unless charge is complete).Finally got around to finishing this (photo should be attached). Plug is rated at 20A 125V. During charging, all connections and cords are far cooler than with the stock C13 socket. Plus, installation required no soldering or heat shrink (I've never mastered either).
I’m guessing the heat damaged wire was a result of the 1/4” stakeon connections & after eliminating them you’ll be good to go.
Make sure you cut out the heat damaged wires &/or dress up the individual strands with Scotchbrite before making your splices. I recommend utilizing plenty of heat shrink to insure a good waterproof repair.