ElectricMotorcycleForum.com

Makes And Models => Zero Motorcycles Forum | 2013+ => Topic started by: PL3 on November 14, 2020, 04:52:31 AM

Title: tail tidy
Post by: PL3 on November 14, 2020, 04:52:31 AM

Is there one for an SR/S?

Title: Re: tail tidy
Post by: Shadow on November 14, 2020, 09:44:47 AM

Quote from: PL3 on November 14, 2020, 04:52:31 AM

Is there one for an SR/S?

R&G Racing LP0148BK?

Title: Re: tail tidy
Post by: Hans2183 on November 15, 2020, 03:37:16 PM

Nee prepared for lots of mud and water being picked up and thrown at your back. At least for the SRF with the short rear seat. The SRS is longer so maybe that works better.

I tried removing the rear mounted fender but had to put it back after the first wet ride. Numberplate and blinkers are since then mounted where the bottom part of the optional rear rack is fitted.

Tip of you remove the rear fender look within the cable cover material for the plate light for a connector cause it's hidden in there. Unplugging that allows for rerouting that wire underneath the seat without cutting.

Even with an extended rear fender I had to put the rear mounted fender back. See this test ride.

https://www.youtube.com/watch?v=sUndUeI_ukA&t=8m5s

Title: Re: tail tidy
Post by: karlh on November 16, 2020, 01:13:41 AM

Quote from: PL3 on November 14, 2020, 04:52:31 AM

Is there one for an SR/S?

The only one I've ever found is by Corbin - https://www.corbin.com/zero/zsrs20tail.shtml

It requires some drilling.  Click on NOTES below the picture for instructions and a drilling template.